Author: Made Ananda Krisna, General Practitioner, Cipto Mangunkusumo Hospital, Faculty of Medicine Universitas, Indonesia; Chief Editor: Hon A/Prof Amanda Oakley, Dermatologist, Hamilton, New Zealand, September 2015. Revised February 2021
Thermal injury due to electrical flash versus a current flowing directly through the body.
A severe or fatal injury caused by an electric shock is known as electrocution.
Who gets an electrical burn?
Electrical injuries are a relatively uncommon cause of burns but result in approximately 1000 deaths each year in the US. Anyone in contact with an electric current can get an electrical burn. Typically, a low-voltage electrical injury/burn patient is a healthy young man at home or in the workplace. High-voltage injuries are less commonly occupational. One third of high-voltage electrical injuries are due to lightning. A recent art-form, fractal wood burning, is being reported to cause high-voltage electrical burns.
What causes an electrical burn?
Electricity is defined as a flow of electrons. Electrons flow when there is a difference of electrical potential between by two points (voltage). The higher the voltage, the higher the current of electrons (the Law of Ohm).
The extent and severity of skin damage depends on:
The strength of the current: a function of voltage and tissue resistance
Type of electrical circuit (direct or alternating current)
The pathway taken by the current through the body
Duration of contact.
What are the clinical features of an electrical burn?
Electrical injury results in tissue/organ damage through three mechanisms:
An electric current passes through the body tissues and causes direct injury
Electrical energy is converted into thermal energy
An indirect mechanical effect causing uncontrolled muscle contraction and falls, particularly with high-voltage injuries.
Low voltage electrical burn
Low voltage electric current results in 2 well-circumscribed deep partial-thickness or full-thickness electrothermal burns:
Contact burn at entry site (eg, hands, skull)
Exit wound (eg, heels in contact with the ground).
High voltage electrical burn
High voltage injury may be due to direct contact or flashing.
Direct contact, high-voltage injury causes a painless, full-thickness, indented, yellowish-grey skin burn that is sometimes accompanied by central necrosis.
Flashing high voltage injury can cause a superficial burn, a partial thickness burn, or devastating full-thickness injury brought about by an electric arc.
An electric arc or spark, including a lightning strike, is produced between a highly-charged source and the ground, reaching temperatures of up to 2500C.
This high temperature directly burns the skin.
The spark ignites clothing; the ensuing flames also burn the skin.
Electrical current flowing through body tissues cause electrothermal heating.
It results in kissing burns.
A kissing burn is an electric arc generated between two skin surfaces facing each other and sandwiching a joint, typically the elbow and knee flexures. The arc crosses the flexor crease and burns the two 'kissing' skin surfaces causing vast underlying tissue destruction.
Assessment of cutaneous involvement alone may underestimate the extent of underlying tissue damage.
How is an electrical burn diagnosed?
Preceding electrical exposure confirms the diagnosis of an electrical burn.
In an unconscious patient in an appropriate environmental setting:
Include electrical injury in the differential diagnosis
Activate the Advanced Trauma Life Support protocol, safely securing the airway, breathing, and circulation
Carefully examine all organ systems (see below)
Calculate total body surface area (TBSA) of skin burn
Monitor neurovascular status of extremities to detect compartment syndrome.
Skin
Cutaneous burn
Heart
Arrhythmia
Cardiac arrest
Respiratory system
Respiratory arrest caused by respiratory muscle tetany or central nervous system dysfunction
Vascular system*
Development of an aneurysm
Tissue ischaemia
Neurological system*
Impairment of consciousness
Paralysis and paraesthesia (usually transient)
Peripheralneuropathy
Spinal cord injury
Musculoskeletal system*#
Muscle necrosis and compartment syndrome
Fractures/dislocation
Kidney
Renal failure caused by myoglobinuria if extensive muscle necrosis
Other
Cataracts
Neuropsychological effects
Note:
*Vessels, nerves, and muscles are good conductors and are directly destroyed as electrons pass through them.
#Bone and tendons have the highest resistance to electrical current; electrical energy is converted into heat causing thermal injury.
Calculating total body surface area
There are several ways to determine the TBSA.
Rule of nines: the proportion of body surface area in adults is different from that in infants and children.
The Lund and Browder chart is more accurate than rule of nines in children and infants.
Use the size of the patient’s hand to represent 1% of TBSA.
Electrocardiography
Electrocardiography (ECG) should be performed in every electrical burn case. Continuous cardiac monitoring is required if there is documented arrhythmia and signs of ischaemia, history of loss of consciousness, or suspected high voltage electrical injury.
Other tests
Complete blood count, electrolytes, blood urea nitrogen, and creatinine are ordered for patients with substantial injuries or if there is a risk for conductive electrical injuries (presence of entry and exit wounds or rhythm abnormalities).
Urinalysis for the presence of blood without red blood cells may indicate myoglobinuria due to muscle destruction.
Creatinine kinase level should be measured in high voltage injuries because its peak concentration predicts extent of muscle injury, amputation risk, mortality, and length of stay.
What is the treatment for an electrical burn?
Pre-hospital setting
In the pre-hospital setting, priorities are to:
Secure the scene: make sure the patient is no longer in contact with live wires before touching them.
Turn off the power source suspected to be the cause of electric burn/injury
Evaluate an unconscious patient for possible cardiac arrest and institute cardiopulmonary resuscitation (CPR)
Provide fluid resuscitation and pain management.
Management of an electrical burn wound
Management of electric burn wounds should include:
Cleansing: debride loose tissue and blister remnants
Silver sulfadiazine cream: broad spectrum, good safety profile, but unable to penetrate eschar
Mafenide cream: broad spectrum, can penetrate eschar but may cause metabolic acidosis and application is painful
Silver nitrate: broad spectrum, must be applied every 4 hours, stains, and has a potential osmolar diluting capacity.
Surgical management
Early decompression procedure is required for a contracted and tight compartment of extremity (eg, forearm, leg) based on a peripheral neurovascular evaluation.
Progressive sensory and motor dysfunction
Severe pain
Loss of arterial signal on Doppler ultrasound
Inadequate early resuscitation
Surgical debridement of unhealthy tissue followed with definitive wound closure is done at day 3 to 5 once the injured tissue is well demarcated.
Excision and grafting may be required for contractures a few weeks following deep partial thickness and full thickness burns.
What is the outcome of an electrical burn?
Deep partial-thickness or full-thickness wounds inevitably cause scarring. Other potential long-term complications of electrical burn injuries include:
Neurological deficits: peripheral neuropathy and central nervous system dysfunction: these develop in several weeks to months
Post-traumatic stress disorder and major depression
Cataracts if the eye has been injured
Heterotopic ossification and neuromas.
Electrical burns can be immediately fatal particularly if due to low-voltage exposure or lightening. High-voltage injuries cause more morbidity than low-voltage burns including more medical complications, require more surgical interventions, and have a greater psychological impact.
Bibliography
Akoz A, Ozogul B, Avsar U, Cakir Z, Aslan S, Mucahit E, Bayramoglu A. Socio-demographic characteristics of patients with electrical burns admitted to emergency department. JAEM. 2015;14:26–9. doi: 10.5152/jaem.2015.70446. Journal
Czuczman AD, Zane RD. Electrical injuries: a review for the emergency clinician. EB Medicine. 2009;11(10):1–24. Journal
Ghavami Y, Mobayen MR, Vaghardoost R. Electrical burn injury: a five-year survey of 682 patients. Trauma Mon. 2014;19(4):e18748. doi:10.5812/traumamon.18748. Journal
Klein MB. Thermal, chemical, and electrical injuries. In: Thorne CH, Beasley RW, Aston SJ, Bartlett SP, Gurtner GC, Spear SL (eds). Grabb and Smith’s Plastic Surgery. 6th edn. Lippincott Williams & Wilkins; 2006. p. 132–49.
Richardson C, Johnston K. An unusual case of high-voltage electrical injury involving fractal wood burning. J Am Coll Emerg Physicians Open. 2020;2(1):e12330. doi:10.1002/emp2.12330. Journal
Shih JG, Shahrokhi S, Jeschke MG. Review of adult electrical burn injury outcomes worldwide: an analysis of low-voltage vs high-voltage electrical injury. J Burn Care Res. 2017;38(1):e293–8. doi:10.1097/BCR.0000000000000373. PubMed